Rep 7.1 Tray 1 (Mpt) - Xerox Phaser 7760 Service Manual

REP 7.1 Tray 1 (MPT)

Parts List on PL 2.11
Removal
1. Remove the Rear Cover (REP 14.2).
2. Remove the Rear Left Middle Cover
3. Open the Left Door Transport (Left-Hand Cover).
4. Removing Tray 1 (Figure 1).
a. Disconnect the wiring harness and Clip from the printer's frame.
b. Remove the 2 screws securing Tray 1.
c. Pull Tray 1 out of the Printer while slightly lift on the right-hand side of the assembly.
Figure 1 Removing Tray 1 (MPT)
Revised
Phaser 7760 Color Laser Printer
(REP 14.4).
Replacement
DO NOT pinch the wires between the left bracket and the left screw hole.
NOTE: The Duplex Chute must be in up position before installing Tray 1. Open Door A, position
the Chute in the proper position, and then close the door.
1. Open Door A, position the Chute in the proper position, and then close the door.
2. Install Tray 1.
January 2010
4-19
CAUTION
Repairs and Adjustments
REP 7.1