Xerox Phaser 7760 Service Manual page 563

7. Measure A and B on both Booklet jobs and verify X1 against specification in
Figure 1 Staple Position
8. If X1 is within specification, the complete Booklet Maker setup is done. If X1 is out of
specification, go to the Adjustment procedure.
Revised
Phaser 7760 Color Laser Printer
Figure 1. Adjustment
1. Enter Service Diagnostics
Printer Status Page >hold the Up and Down buttons simultaneously > Run Service
Diagnostics > OK.
2. Select Adjustments/Calibrations and press OK.
3. Select Finisher Fold Position and press OK.
4. Select ADJ 12.10 and press OK.
5. Perform adjustment using Adjustment locations in
NOTE: If the "A"-side is longer than the "B"-side, the current NVRAM value should be
increased. If the "B"-side is longer than the "A"-side, the current NVRAM value should be
decreased.
Job # Default Range
1 100 0 ~ 200
2 100 0 ~ 200
3 100 0 ~ 200
4 100 0 ~ 200
6. Check the output against specifications in
meets specification or customer request.
January 2010
4-121
Menu: Printer Menu > Troubleshooting > Service Tools >
Table 2.
Table 2 Adjustment Locations
Remark
1 count = 0.1 mm. Target amount to be adjusted is half the
amount of the total Fold Misalignment.
1 count = 0.1 mm. Target amount to be adjusted is half the
amount of the total Fold Misalignment.
1 count = 0.1 mm. Target amount to be adjusted is half the
amount of the total Fold Misalignment.
1 count = 0.1 mm. Target amount to be adjusted is half the
amount of the total Fold Misalignment.
Figure 1. Repeat step 5 until the Staple Position
Repairs and Adjustments
ADJ 12.10