Xerox Phaser 7760 Service Manual page 257

012-161 Set Eject Jam
The Compile Exit Sensor did not turn Off within the specified time after the Eject operation has
begun.
Initial Actions
• Check the Buffer Reverse Roll for wear or damage.
• Check the Compile Exit Roll for wear or damage.
• Check for paper transportation failure due to a foreign substance/burr on the paper path.
• Check for transportation failure of non-standard paper.
Procedure
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer
Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics >
OK. Actuate the Compile Exit Sensor (PL
Y N
Check the circuit of the Compile Exit Sensor
Sensor Procedure for troubleshooting procedure.
Perform the Paper Path/No Pick test, Exit Motor. The Exit Motor
Y N
Check the circuit of the Exit Motor (Figure
shooting procedure.
Perform the Finisher Solenoids test. The Transport Gate Solenoid
Y N
Check the circuit of the Transport Gate Solenoid
RAP for troubleshooting procedure.
Check the following:
• Ensure that the connectors shown in the circuit diagrams are securely connected and that
the wires are not damaged
• Check the Exit Motor and its associated gears and belts for damage, contamination or
tension
If the above checks are OK, then replace the Compile Exit Sensor
persists, replace the Finisher PWB (PL 21.12).
Revised
Phaser 7760 Color Laser Printer
21.9). The display changes.
(Figure 1). Refer to Section 6, Transmissive
(PL 21.8) energizes.
1). Refer to Section 2, OF 99-9 RAP for trouble-
(PL 21.10) actuates.
(Figure 1). Refer to Section 2,
(PL 21.9). If the problem
OF 99-8
January 2010
2-221
Status Indicator RAP's
012-161