012-307 Booklet Drawer Set Fail
Booklet Drawer Set Sensor OPEN was detected.
Initial Actions
•
Check the Booklet Drawer Set Sensor for improper installation.
•
Check the Booklet Drawer Set Sensor connectors for connection failure.
•
Check the Actuator part for deformation.
Procedure
Enter
Service Diagnostics
Menu: Printer Menu > Troubleshooting > Service Tools > Printer
Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics >
OK. Perform the Booklet Drawer Set Sensor test. Remove and insert the Booklet Drawer
21.15) manually. The display changes.
Revised
Phaser 7760 Color Laser Printer
Y
N
Check continuity between the Booklet Drawer Set Sensor and Finisher Main PWB
1). The continuity check is OK.
Y
N
Repair the open circuit or short circuit.
Replace the Booklet Drawer Set Sensor
Finisher PWB
(PL
If the problem continues, replace the Finisher PWB
(PL
Figure 1 012-307 Booklet Drawer
January 2010
2-303
(PL
21.15). If the problem continues, replace the
21.12).
(PL
21.12).
(Figure
Status Indicator RAP's
012-307