Hyundai Elantra 2024 Owner's Manual page 52

Seats & safety system
To install a Child Restraint System on the
rear seats:
1. Place the Child Restraint System on a
rear seat and route the lap/shoulder
belt around or through the Child
Restraint System, following the Child
Restraint System manufacturer's
instructions. Make sure the seat belt
webbing is not twisted.
Information
When using the rear center seat belt,
refer to the "Passenger and rear seat
belts - 3-point system with convertible
locking retractor" section in this
chapter.
2. Fasten the lap/shoulder belt latch into
the buckle. Check a distinct "click"
sound is heard.
B0065KO03
Information
Position the release button so it is easy
to access in an emergency.
3-34
3. Pull the shoulder portion of the seat belt
all the way out. When the shoulder
portion of the seat belt is fully
extended, it shifts the retractor to the
Automatic Locking (child restraint)
mode.
B0065KO04
4. Slowly allow the shoulder portion of the
seat belt to retract and listen for an
audible "clicking" or "ratcheting"
sound. This indicates that the retractor
is in the Automatic Locking mode. If no
distinct sound is heard, repeat Step 3
and 4.
B0065KO05
5. Remove as much slack from the belt as
possible by pushing down on the Child
Restraint System while feeding the
shoulder belt back into the retractor.