Reducing The Temperature; Maximum Rinse Level; Suds Cooling; Anti-Crease - Miele WWD 660 WCS Operating And Installation Instructions

 Reducing the temperature
At high altitudes, water has a lower
boiling point. Miele recommends
switching on the reduce temperature
setting at altitudes of 6,560 ft
(2,000 m) or above to prevent water
from boiling. The maximum tempera-
ture is reduced to 176°F (80°C), even if
a higher temperature has been se-
lected.
Options
 = The reduce temperature setting
is switched off (factory set-
ting)
 = The reduce temperature setting
is switched on
 Maximum rinse level
The water level in the rinse can be
permanently set to the highest value.
This function is important for allergy
sufferers as it achieves excellent wash
results. The water consumption will be
increased.
Options
 = Maximum rinse level is
switched off (factory setting)
 = Maximum rinse level is
switched on
Programmable functions
 Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a Nor-
mal program with a temperature of
158°F (70°C) or higher is selected.
Suds cooling should be activated:
- To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
- Where the drainage pipes do not
comply with DIN 1986.
Options
 = Suds cooling is switched off
(factory setting)
 = Suds cooling is switched on
 Anti-crease
The Anti-crease function helps prevent
creasing after the end of the program.
At the end of the program, the drum
continues to turn for up to 30 minutes.
The door can be opened at any time
during the Anti-crease phase.
Options
 = The Anti-crease function is
switched off
 = The Anti-crease function is
switched on (factory setting)
83