Starting The Fireplace For The First Time; Turning The Fireplace On And Off; Adjusting The Flame Height - FireplaceXtrordinair ProBuilder GSB2 42 Owner's Manual

Starting the Fireplace for the First Time


Burn the heater at a high setting with the blower off for an extended period (up to 48 hours). This will
cure the painted surfaces. Fumes from the paint curing and oil burning off the steel will occur. This
is normal. We recommend opening a window to vent the room.

Condensation may appear on the glass each time you start the fireplace - this is normal.

Blue Flames will occur on the fireplace when it first comes on. After fifteen minutes the flames will
turn a more realistic yellow and orange color.

Certain installations use a remote, thermostat, or wall switch to turn the fireplace on and off. If this is
the case, leave the ON/OFF switch "ON".

Verify the power backup and control light batteries are installed.

Turning the Fireplace On and Off

After the pilot has been started...
O
O
ON/OFF SWITCH
Use this switch to turn the main
burner on and off manually.

Do not place any combustible items on top of or directly in front of the heater, even temporarily. The
optional thermostat may start the heater causing a combustible item to ignite.

If the heater turns on and off frequently while using the thermostat, you may want to adjust the flame
height down until it produces just enough heat needed.

Adjusting the Flame Height

This fireplace has an adjustable flame to tailor the look and heat output to your specific needs. It is
adjusted by turning the flame adjust knob.
© Travis Industries
Operation
OPTIONAL REMOTE THERMOSTAT
See the instructions included with the remote
for details on operation.
8/7/19 - 1451
7
PB Lin GSB2 Operation