Table of Contents
Advertisement
Adjusting the Transmission
Belt Tensioner
The transmission belt is tensioned by a spring-loaded idler
pulley. If you must engage or disengage the belt tension,
use a 3/8-inch wrench to rotate the engage/disengage shaft
(Figure
49) to the desired position. Rotating the shaft 1/4
turn clockwise disengages the idler from the belt
Note: You must disengage the belt tension before removing
the transmission cover.
Note: The transmission belt is properly tensioned when
the alignment marks on the transmission cover and the
engagement shaft are aligned.
1
Figure 50
1. Engaged
(Figure
50).
2
G019886
g019886
2. Disengaged
Controls System
Maintenance
Adjusting the Reel Control
If the reel control does not properly engage, an adjustment
is required.
1. Turn off the machine and disconnect the battery pack.
2. Ensure that the reel control is disengaged.
3. At the transmission bulkhead, adjust the reel control
cable
(Figure
51), to attain a spring length of 70.6 to
72.4 mm (2.78 to 2.85 inches).
1
2
1. Reel control cable
4. At the control handle bulkhead, loosen the reel control
cable until there is slack in the cable
39
G017384
Figure 51
2. Jam nuts
(Figure
52).
g017384
Advertisement
Table of Contents
