Visually Inspecting The Reel Clutch; Engaging/Disengaging The Transmission-Belt Tensioner - Toro Greensmaster Flex 2120 Operator's Manual

C. Clean any debris from inside the belt
compartment and from around the
compression spring
D. Ensure that the compression spring is
applying the proper tension on the belt.
E. Tighten the bearing housing mounting nut.
F. Install the belt cover.
Visually Inspecting the Reel
Clutch
Remove the rubber plug
the front of the transmission to visually inspect the
reel clutch when making adjustments.
Important:
Replace the plug when finished to
prevent water and debris from contaminating the
clutch.
Figure 45
1. Rubber-hole plug
(Figure 44).
(Figure 45) from the hole in
2. Engage/disengage shaft
Engaging/Disengaging
the Transmission-Belt
Tensioner
The transmission belt is tensioned by a spring-loaded
idler pulley. If you must engage or disengage the
belt tension, use a 3/8-inch wrench to rotate the
engage/disengage shaft
position. Rotating the shaft 1/4-turn (90°) clockwise
disengages the idler from the belt
Note:
You must disengage the belt tension before
removing the transmission cover
Note:
The transmission belt is properly tensioned
when the alignment marks on the transmission cover
and the engagement shaft are aligned.
1. E
NGAGED
g016949
36
(Figure 45) to the desired
(Figure 46).
Figure 46
2. D
ISENGAGED
g019886