Installing The Target Plate; Installing The Weight Rod - Toro Greensmaster eFlex 1820 Operator's Manual

Note: Determine the left and right sides of the machine
from the normal operating position.
Note: To install the weight rod onto your machine, refer to
the installation instructions in your Cutting Unit Operator's
Manual.
1

Installing the Target Plate

Parts needed for this procedure:
1 Target plate
Procedure
1. Setup and prepare the cutting unit as described in the
cutting unit Operator's Manual.
2. Remove the center, grass-shield bolt
3. Install the target plate to the top of the cutting unit
using the bolt that you removed previously
2
G017294
1. Center, grass-shield bolt
(Figure 3).
(Figure
1
Figure 3
2. Target plate
2

Installing the Weight Rod

Parts needed for this procedure:
1 Weight rod
1 Flange-head bolt
Procedure
1. Enlarge the lower hole on the right side of the cutting
unit using a 9 mm (23/64 inch) drill bit
3).
2. Lubricate the O-ring on the weight rod.
3. Insert the O-ring end of the weight rod into the
previously drilled hole.
4. Secure the threaded end of the weight rod to the frame
using a flange-head bolt
g017294
10
(Figure
G026123
Figure 4
(Figure 5).
4).
g026123