Table of Contents
Advertisement
1
G017299
Figure 52
1. Reel control cable
5. At the control handle bulkhead, tighten the reel control
cable enough to remove the slack from the cable
without extending the spring.
6. Check the operation as follows:
•
Verify that the reel clutch teeth disengage when the
clutch is released and the reel clutch teeth do not
bottom out when engaged.
Note: Remove the rubber plug
the hole in the front of the transmission to view
reel clutch.
•
The reel stopping time must be less than 7 seconds
with the reel to bedknife backed off.
•
Refer to the Service Manual or contact your
Authorized Toro Distributor for further assistance.
2
g017299
2. Jam nuts
(Figure
49) from
Cleaning
Cleaning the Machine
Service Interval: After each use
After each use, wash the machine with mild detergent
and water. Do not pressure wash the machine. Avoid
excessive use of water, especially near the shift lever plate,
the InfoCenter, the power center, and the machine power
connector. Ensure that you get the motor clean to provide
proper cooling during operation. Also, keep the battery pack
as clean as possible so that it stays white. This reflects sunlight
and keeps the batteries from overheating in the sun.
Important: Always store/park the machine out of direct
sunlight as heating from the sun reduces the life span
of the battery pack.
40
Advertisement
Table of Contents
