Table of Contents
Advertisement
Important: Do not use other light systems with this
mower as they may damage the battery pack or electrical
system.
Operating the Machine
1. Turn on the machine, set the speed control to the
position, push down on the handle to raise the
ZERO
cutting unit, press the operator presence control, move
the traction lever to the
35), and gradually increase the speed control setting to
transport the mower onto the collar of the green.
2. Return the speed control to the
3. Disengage the traction lever, then move it to the
left and forward, engaging the traction and reel drive
(Figure
35).
Figure 35
1. Neutral
2. Traction drive neutral and
reel drive off
4. Gradually increase the speed control setting until the
mower is traveling at the desired ground speed, drive
the mower out onto the green area, lower the front of
the mower down, and begin mowing.
Note: While mowing, you can move the speed control
to the
position. This will stop the machine
ZERO
with the motor brake off, allowing you to pull the
machine rearward to make course corrections. For
more information on the automatic motor brake, refer
to
Automatic Motor Brake (page
position
(Figure
ENGAGED
position.
ZERO
3. Traction drive-engaged
(transport)
4. Traction drive and reel
drive engaged
19).
Preparing to Transport the Machine
after Mowing
1. Drive off the green, reduce the speed to the
position, disengage the reel drive and traction control
levers, and turn off the machine.
2. Empty the grass basket of clippings, install the grass
basket on the mower, and begin transporting.
g000494
24
ZERO
Advertisement
Table of Contents
