Installing The Handle Retainers - Toro Greensmaster eFlex 1820 Operator's Manual

1
2
3
Figure 8
1. Kickstand—storage
position
2. Locking pin
3. Push the cutting unit under the traction unit and to the
left to engage the transmission coupling
Figure 9
1. Transmission coupling
4. Maneuver the traction unit frame
until it engages the cutting unit pivot arms.
G017356
3. Kickstand—service
position
(Figure 9).
(Figure 10) forward
3
2
1
G017242
Battery platform not shown
g017356
1. Telescoping coupler
2. Cutting unit hex shaft
5. Secure the traction unit frame to the cutting unit pivot
arms with 2 bolts (3/8 x 3/4 inch)
Note: To remove the cutting unit, just loosen the 2
bolts (3/8 x 3/4 inch) approximately 1-1/2 turns and
rotate the pivot arms out.
6. Push down on the kick stand to release the spring
loaded locking pin and allow the kick stand to rotate
up to the storage position.
7. Set the height-of-cut of the reel as described in the reel
Operator's Manual.
5

Installing the Handle Retainers

g000483
Parts needed for this procedure:
2 Handle retainer
2 Hairpin cotter
Procedure
1. While supporting the handle, remove the cable ties
securing the handle clamps to the side plates
11).
12
Figure 10
3. Bolt
(Figure 10).
g017242
(Figure