Table of Contents
Advertisement
7. Place the battery pack on the base with the connector
port toward the rear of the machine.
8. Secure the battery pack to the base using 6 bolts (5/16
x 1/2 inch) and washers.
Note: Torque each bolt to 11.3 to 14 N∙m (100 to 130
in-lb).
9. Line up the tabs on the inside of the harness power
plug with the slots in the battery pack receptacle.
Note: Press the harness connector into the battery
connector
(Figure 14
1
2
3
4
G017236
Figure 14
1. Battery-pack receptacle
2. Locking collar
Figure 15
and
Figure
15).
3. Pack the machine to the
wire-harness plug
4. Bolt securing the battery
pack
G017358
10. Rotate the locking collar on the harness plug clockwise
until it engages with the battery receptacle and begins
to pull in toward the battery.
Note: Continue turning it another 120 degrees (1/3
of a turn) until it fully seats.
Note: If you cannot mate the battery pack receptacle
with the machine wire harness plug while the battery
pack is installed, you can instead connect the harness
to the battery pack and then install the battery pack.
Remove the main power supply connector
17) from the battery base. Install the connector to
the battery as described. Install the battery to the
base, threading the attached wire harness through the
appropriate hole, and then secure the main power
supply connector to the battery base using the fasteners
previously removed.
11. Remove the screwdriver holding the battery base in the
up position, and gently lower the battery platform to
the machine frame.
Important: Do not pinch the wire harness
between the frame and platform.
12. Secure the battery platform to the machine frame with
the tall nut removed in step 4.
13. Tighten the pivot fasteners loosened in step 5.
14. Route the pack to machine wire harness under and
behind the main harness on the left side of the machine
and connect the small, 6-pin connector on the harness
g017236
to the matching connector on the main wire harness as
shown in
Figure
2
g017358
1. Connector on the main
wire harness
14
16.
1
G017235
Figure 16
2. Small connector from the
pack to machine wire
harness
(Figure
g017235
Advertisement
Table of Contents
