Servicing The Traction Interlock Switch; Servicing The Mow Sensor - Toro Greensmaster eFlex 1820 Operator's Manual

1
G017425
Figure 43
1. Fuse cover
C. Check the fuse and replace it if it is blown.
Use only a Toro fuse (Part No. 119-1208)
to replace this fuse. This fuse is specially
designed for the battery pack. Other fuses
may cause irreversible damage to the pack.
D. Replace and secure the fuse cover. Torque the
cover screw to 0.34 N∙m (3 in-lb).
E. Lower and secure the battery platform.
Servicing the Traction
Interlock Switch
Use the following procedure if the traction interlock switch
needs adjustment or replacement.
1. Turn off the machine and disconnect the battery pack.
2. Remove the control panel.
3. Engage the traction lever.
g017425
1. Traction lever
2. Mow sensor flag
4. Loosen the interlock switch mounting fasteners
44).
5. Place a 1.6 mm (0.062 inch) thick shim between the
traction lever and the interlock switch
6. Tighten the interlock switch mounting fasteners.
Recheck the gap. The traction lever must not contact
the switch.
7. Engage the traction lever and check the gap. The
normal operating range is between 0.76 to 3.05 mm
(0.03 to 0.12 inch). With the traction lever engaged,
verify that the switch loses continuity. Replace the
switch if required.

Servicing the Mow Sensor

Use the following procedure if the mow sensor needs
adjustment or replacement.
1. Turn off the machine and disconnect the battery pack.
2. Remove the control panel.
3. Push the traction lever to the left and engage the
mower.
4. Loosen the mow sensor mounting fasteners
44).
5. Place a 1.6 mm (0.062 inch) thick shim between the
mow sensor flag and the mow sensor
6. Tighten the sensor mounting fasteners. Check the gap.
The flag must not contact the sensor.
7. Engage the traction lever in mowing mode and verify
that the switch loses continuity. Replace the sensor if
required.
36
G017298
Figure 44
3. Mow sensor
4. Traction interlock switch
(Figure
(Figure
g017298
(Figure
44).
(Figure
44).