Installing The Handle Retainers; Installing The Transport Wheels - Toro Greensmaster Flex 1800 04040 Operator's Manual

2

Installing the Handle Retainers

Parts needed for this procedure:
2 Handle retainer
2 Hair pin cotter
Procedure
1. While supporting the handle, remove the cable ties
securing the handle clamps to the side plates
1. Hair pin cotter
2. Pivot the handle to the desired operating position,
insert a handle retainer over the handle clamp and into
the matching holes in the side plate
3. Secure the clamp in position with a hair pin cotter
(Figure 6).
4. Repeat the procedure on the opposite side of the
handle.
5. Adjust the handle height to the desired position; refer
to Adjusting the Handle Height (page
Note: The machine is shipped with the handle
adjusted to the lowest position. The machine is
traditionally operated with the handle telescoped out to
its maximum height.
(Figure
Figure 6
2. Handle retainer
(Figure 6).
18).
3
Installing the Transport
Wheels
Parts needed for this procedure:
Transport wheels (Optional Transport Wheel Kit,
2
Model 04123)
Procedure
1. Push the kick standdown with your foot in the
6).
center of the kick stand and pull up on the lower
center machine handle until the kick stand has rotated
forward, over center
1. Kick stand
2. Press the wheel locking clip toward the center of wheel
and slide the wheel onto the hex shaft
1. Locking clip
11
(Figure 7).
Figure 7
(Figure
Figure 8
8).