Checking The Oil-Pressure-Warning Light - Toro Workman 07390H Operator's Manual

Figure 44
1. Drain plug
2. Forward
3. Remove the drain plug and let the oil flow into a
drain pan (Figure
4. When the oil stops draining, install the drain
plug.
5. Remove the oil filter from the filter adapter
(Figure 45).
Figure 45
1. Forward
2. Oil filter
6. Wipe clean the sealing base of the of the filter
adapter (Figure 45).
7. Apply a light coat of clean oil to the seal of the
new filter.
8. Install the filter until the gasket contacts the
sealing base of the filter adapter, then tighten
the filter clockwise and additional 1/2 to 2/3 of
a turn (Figure 45).
Note:
Do not overtighten the engine-oil filter.
44).
3. Filter adapter
9. Add the specified oil to the crankcase of the
engine.
Checking the
Oil-Pressure-Warning
Light
Service Interval: Before each use or daily
Note:
If you just shut off the engine, it may take 1 to
2 minutes for the light to come on.
1. Engage the parking brake.
g025525
2. Turn the key switch to the O
not start the engine.
Note:
The oil-pressure light should glow red.
Note:
If the light does not function, either a bulb
is burned out, or there is a malfunction in the
system that you must repair.
g025524
41
position, but do
N