Remove The Dc-In Bracket; Remove The Thermal Module - Lenovo Legion Pro 7i Hardware Maintenance Manual

Remove the DC-in bracket

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove two screws and then remove the DC-in bracket.
Figure 19. Remove the DC-in bracket
Screw specifications
M2 x L6
Go to
https://support.lenovo.com/partslookup
part:
DC-in bracket

Remove the thermal module

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 28
"Remove the solid-state drive (SSD) plate (L or R)" on page 29
Note: Place the computer on a level table. After removing the thermal module, place it horizontally on the
table. Make sure that the side of the thermal module that touches the liquid metal is facing upwards to
prevent the liquid metal from flowing onto other components.
Step 1. Detach the thermal module cable connectors and then remove four screws.
Number of screws
2
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
37