Siemens MindConnect Nano System Manual page 34

Configuring data in Asset Manager
3.7 Browsing datapoint of a data source for MindConnect Nano
After adding the data source, you can browse the datapoints for the selected data source.
This feature is only supported for OPC UA protocol.
During configuration of data points via browsing feature, performance may get
impacted depending on the configuration and data points in Data Sources.
Prerequisite
You have created a data source.
After creating the data source, click "Save" and "Apply changes".
Procedure
To browse the datapoints of a data source, follow these steps:
1. Click "Enter Edit Mode" and select the datasource.
2. Click
3. Select the required data points.
4. Click "Save" and then click "Apply changes".
Result
The available datapoints are displayed for the selected data source.
① Check and uncheck to select the datapoints of a data source
② List of the datapoints of the selected data source
MindConnect Nano
System Manual 7/2023
to browse the datapoints of the data source.
34