Setting Up The Pptp Vpn Client (Windows) - TRENDnet TEW-929DRU User Manual

TRENDnet User's Guide
operating system or mobile device User's Guide/Manual for configuring the VPN
settings.
Below is a reference of the additional PPTP VPN server settings if you choose to make
other configuration changes to these sections.
•
Enable – Check this option to enable the PPTP VPN server.
•
Local IP – Enter an IP address for the PPTP VPN server. This should be the same
as your LAN IPv4 address to allow both access to LAN network and Internet to
VPN clients via full tunneling. (e.g. 192.168.10.1)
•
Client IP – Enter the IP address pool to distribute to your PPTP VPN clients after
they establish VPN connectivity. This should be in the same IPv4 subnet used as
your Local IP address. If using the same as the router LAN IP address, make sure
to assign a range different from your LAN DHCP server IP range. (e.g.
192.168.10.10-192.168.10.20)
•
MS-DNS 1 – Enter the IPv4 address of the primary DNS server to distribute to
PPTP VPN clients after they establish VPN connectivity. This parameter is
optional. (e.g. 8.8.8.8)
•
MS-DNS 2 – Enter the IPv4 address of the secondary DNS server to distribute to
PPTP VPN clients after they establish VPN connectivity. This parameter is
optional. (e.g. 8.8.4.4)
•
MS-WINS 1 – Enter the IPv4 address of the primary WINS server to distribute to
PPTP VPN clients after they establish VPN connectivity. This parameter is
optional. (e.g. 192.168.10.32)
•
MS-WINS 2 – Enter the IPv4 address of the secondary WINS server to distribute
to PPTP VPN clients after they establish VPN connectivity. This parameter is
optional. (e.g. 192.168.10.33)
•
Authentication – Click the drop-down list and select the authentication
protocol to use for PPTP VPN authentication, PAP/CHAP/MS-CHAPv1/MS-
CHAPv2. It is strongly recommended to use MS-CHAPv2 since it offers the
highest degree of security from these options and is supported by most
modern computers and mobile devices.

Setting up the PPTP VPN client (Windows)

Note: This procedure provides a basic example how to setup PPTP VPN and establish
connectivity using a Windows® 10 client computer. If you are using a different operating
system or mobile device, please refer to the user's guide/manual of the third party
© Copyright 2023 TRENDnet. All Rights Reserved.
operating system or device on configuring PPTP VPN. The PPTP VPN settings must match
with the settings configured on the router.
1. Click the Start button and click the Settings icon.
Start Button Settings icon
2. Click Network & Internet.
3. Click VPN in the left panel.
4. Under VPN, click Add a VPN connection.
5. Click the VPN provider drop-down list and select Windows (built-in).
TEW-929DRU
55