Pptp Vpn Server; Setting Up The Pptp Vpn Server - TRENDnet TEW-929DRU User Manual

Ax1800 dual-band wifi 6 gigabit dual-wan vpn smb router
Table of Contents

Advertisement

TRENDnet User's Guide

PPTP VPN Server

Security > VPN > PPTP Server
You can enable and configure the PPTP VPN server on your router to allow remote
computers or mobile devices with PPTP VPN support to connect securely over the
Internet and access the company LAN network.

Setting up the PPTP VPN server

1. Log into your router management page (see
on page 6).
2. Click on Security, click VPN, and click the PPTP Server tab.
3. Under Service Setting, check the Enable option to enable the PPTP server.
4. In the Local IP field, enter the LAN IP address. (Default LAN IP: 192.168.10.1)
Note: Entering the LAN IP address as the Local IP of the PPTP server ensures your PPTP
VPN clients are able to access the Internet and the router LAN network via full tunneling.
If an IP address different from the LAN IP is entered, PPTP VPN clients will be allowed to
access router LAN and not the Internet.
© Copyright 2023 TRENDnet. All Rights Reserved.
"Access your router management
page"
5. In the Client IP field, enter an IP address range (within the same LAN IP subnet range)
to assign to PPTP VPN clients. By default, the router LAN DHCP server pool is
192.168.10.101-192.168.10.199, therefore, we will assign a range that does not conflict
with the DHCP server range such as 192.168.10.10-192.168.10.20.
6. Click the Authentication drop-down list and select MS-CHAPv2.
7. Under the User Account section, enter a profile name for the new user account and
click Add. (e.g. User1)
8. Check the Enable option and enter a User name and Password for the new user
account. (e.g. User name: user1 / Password: user1)
9. Click Apply and the bottom of the page so save and commit the changes.
10. Click on the Status > Overview page and under the Network section, make note of
your WAN IPv4 addresses to configure the PPTP VPN clients. You can also configure
dynamic DNS to use a dynamic DNS hostname instead of dynamic WAN IP address.
Note: For the VPN client computer, you will require a third party PPTP VPN software to
be installed configured matching the PPTP VPN settings on your router. Typically, PPTP
VPN software is pre-installed with most operating systems. Please refer to your
TEW-929DRU
54

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tew-929dru/ug

Table of Contents