Table of Contents
Advertisement
TRENDnet User's Guide
MWAN Status
• Interface Live Status – This section displays the current status of the WAN
interfaces of your router. Tracking is enabled using physical link status and L2 based
methods but the tracking status displayed refers to the status of IP based link
tracking which can be configured under the Link Tracking section.
Link Tracking – Allows you to setup WAN link tracking by pinging Internet IP addresses.
• Enable Tracking – Checking this option enables IP based WAN link tracking on the
specific WAN interface.
• Tracking hostname or IP – Enter an Internet IP address to send ping requests used
to verify the link status of a specific WAN interface. You can add additional IP
address by clicking
.
• Ping Interval – Click the drop-down list to set the time interval between
consecutive ping requests.
Default Traffic Rule
• Policy – This setting controls the default WAN mode for Internet connectivity access
for all local interface such as LAN, wireless LAN, and VLAN interfaces.
© Copyright 2023 TRENDnet. All Rights Reserved.
o
WAN1 (Failover to WAN2) – This is the default WAN mode. In this
mode, the primary WAN interface is set to WAN1 and secondary WAN
interface is set to WAN2. All traffic will be routed only through WAN1
and will only route to WAN2 for Internet connectivity if the WAN1
primary interface link status fails. If WAN1 connectivity is restored, all
Internet traffic will revert back to the primary WAN1 interface.
o
WAN2 (Failover to WAN1) –In this mode, the primary WAN interface
is set to WAN2 and secondary WAN interface is set to WAN1. All traffic
will be routed only through WAN2 and will only route to WAN1 if the
WAN2 primary fails or is disconnected. If WAN2 connectivity is
restored, all Internet traffic will revert back to the primary WAN2
interface.
o
WAN1 (Fixed) – In this mode, all Internet traffic will only be routed to
the WAN1 interface. The WAN2 interface is not used.
o
WAN2 (Fixed) – In this mode, all Internet traffic will only be routed to
the WAN2 interface. The WAN1 interface is not used.
TEW-929DRU
46
Advertisement
Table of Contents
