Configure Lan Ipv4 Dhcp Server Settings - TRENDnet TEW-929DRU User Manual

TRENDnet User's Guide
Below is a reference of the additional LAN settings if you choose to make other
configuration changes to these sections.
General Setup
•
Status – LAN Interface (br-lan)
o
Uptime – Displays the amount time the LAN interface has been up and
continuously running. This time will reset if the router is powered off
or router is rebooted.
o
MAC-Address – Displays the current MAC address assigned to the LAN
interface.
o
Rx – Displays the total amount of data received by the LAN interface in
MB (# of packets) since the start of the currently displayed uptime.
o
Tx – Displays the total amount of data transmitted by the LAN
interface in MB (# of packets) since the start of the currently displayed
uptime.
o
IPv4: Displays the current IPv4 address settings assigned to the LAN
interface.
•
Mode – Allows you to change the function between NAT mode or Route Only
(NAT-less).
o
NAT – The default router mode which uses network address
translation between the local internal (LAN/VLAN) interfaces and
external (WAN1/WAN2) interfaces translating public and private IP
addressing.
o
Route Only (NAT-less) – This mode disables the NAT function between
internal and external interfaces and may also be known as classical
routing mode. This mode should only be used when the router is using
for local internal IP routing only
Advanced Settings
•
Override MAC Address – This parameter allows you to assign a new LAN
interface (br-lan) MAC address. Typically, this parameter does not need to be
modified. (e.g. AA:BB:CC:DD:EE:FF)
© Copyright 2023 TRENDnet. All Rights Reserved.
•
Override MTU – The default MTU (maximum transfer unit) or frame size is set
to 1500 bytes. This parameter allows you to assign a new MTU size. Typically,
this parameter does not need to be modified.

Configure LAN IPv4 DHCP server settings

Network > LAN
Note: The internal DHCP server function is enabled by default on the LAN interface to
automatically distribute IP address settings to network devices connected to the LAN and
wireless LAN interfaces. The internal DHCP server only supports only class C IP address
range. The default IP range is 101 – 199 (192.168.10.101 – 192.168.10.199)
1. Log into your router management page (see
on page 6).
2. Click on Network and click LAN.
3. Under the DHCP Server/Relay section, you can modify or enter the new DHCP settings
and click Apply to save and commit the changes.
TEW-929DRU
"Access your router management page"
9