Set Up The Dhcp Server On Your Router - TRENDnet TEW-827DRU User Manual

TRENDnet User's Guide

Set up the DHCP server on your router

Advanced > Setup > LAN Settings
Your router can be used as a DHCP (Dynamic Host Configuration Protocol) server to
automatically assign an IP address to each computer or device on your network. The
DHCP server is enabled by default on your router. If you already have a DHCP server on
your network, or if you do not want to use your router as a DHCP server, you can disable
this setting. It is recommended to leave this setting enabled.
1. Log into your router management page (see
on page 10).
2. Click on Advanced and click on Setup, then click on LAN Settings.
3. Review the DHCP Server settings. To save changes to this section, click Apply when
finished. Commit your changes to the router by clicking on Apply/Discard Changes in
the left-hand menu, and click Apply & Reboot.
 DHCP Server: Enable or Disable the DHCP server.
 DHCP Start IP: Changes the starting address for the DHCP server range.
(e.g. 192.168.10.20)
 DHCP End IP: Changes the ending address for the DHCP server range.
(e.g. 192.168.10.30)
Note: The Start IP and End IP specify the range of IP addresses to automatically
assign to computers or devices on your network.
 DHCP Lease Time – Enter the DHCP lease time in minutes.
Note: The DHCP lease time is the amount of time a computer or device can keep
an IP address assigned by the DHCP server. When the lease time expires, the
computer or device will renew the IP address lease with the DHCP server,
otherwise, if there is no attempt to renew the lease, the DHCP server will
reallocate the IP address to be assigned to another computer or device.
© Copyright 2016 TRENDnet. All Rights Reserved.
"Access your router management page"
You can also view the current DHCP clients in the Number of Dynamic DHCP Clients list
under Advanced > Setup > DHCP Client List.
TEW-827DRU
39