Pre-Installation Check List - Genie GPS-IC Owner's Manual

PRE-INSTALLATION CHECK LIST

Things to consider if you are planning to "do-it-yourself."
Whether you are replacing an existing garage door operator or installing an operator in your
garage for the first time, there are some pre-installation issues which need to be addressed.
They are as follows:
2
The Genie Company recommends that you read and fully understand all
information and instructions contained herein before choosing a "Do-It-Yourself "
installation. Any questions should be directed to the Genie Company or an authorized
Genie Dealer.
( The issue numbers below refer to the circled numbers in the illustrations on page 3.
1 Check your ceiling where the power
head of your new unit will be mounted.
Plan how you will be mounting the power head.
It is possible that ceiling joists may not be in the
exact position needed with respect to the garage
door operator. In any case, it may be necessary
to add an additional bracket and fasteners (not
included with your new door operator kit).
2 Check the wall directly above the garage
.
door The door operator's header bracket
must be securely fastened to this wall. Insure
that the structure will provide a strong mounting
location.
3
Check to see if the mounting location
for the Safe-T-Beam
clear from obstruction and has a wood
surface available for attaching the STB
.
brackets The brackets may also be attached to
concrete if necessary but extra tools and special
fasteners (not supplied) will be required.
NOTE: 1-1/2" "STB" bracket adapters
are available through your local Genie Dealer.
Is your garage door made of
4
light-weight steel, aluminum, fiberglass
or glass panels
must be added to these type doors. If this is the
case, please contact the door distributor or
manufacturer so that they can furnish you with a
"bracing kit."
DO NOT USE EXTENSION CORD!
Extension cords can cause dangerous
overheating conditions.
DO NOT USE PORTABLE GENERATOR!
This product is designed to operate on
standard house current. Do not use
alternate power supplies.
® System (STB) is
?
Additional support bracing
WARNING
FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM
You need a 110-120 Volt power supply
5
.
available If you plan to plug the unit into a
standard electrical outlet, is one available? The
outlet should be no more than about 3 feet from the
power head once it is mounted. (The cord is 4 ft. in
length.) SEE WARNING BELOW.
6 To avoid damage to your door and/or
operator, make sure you disable any door
locks prior to installing your operator
7 Insure that your door is properly balanced
and moving freely. SEE WARNING BELOW.
8 (NOT SHOWN) If your garage does not have
a separate entry door, you might want to
consider an emergency release kit ( GER-2 ) for
installation on your garage door. See page 30.
WARNING
If your door sticks, binds, or is out of
balance, have it adjusted by a professional.
Door springs, cables, pulleys, brackets and
associated hardware are under extreme
tension and can cause serious injury or
death.
)
.