Description Of Items - Omron ZN-DPX21-S Series User Manual

4.2.4 Description of items

(1) Measured value update cycle (CYCLE)
Specifies an update interval of measured values.
DPX21
Setting range (selection type):
1s (second) / 2s / 5s / 10s / 20s / 30s / 1m (minute) / 2m / 5m / 10m / 20m / 30m / 1h (hour)
Initial value:
10s
THX21 THX11
Setting range (selection type):
10s (second) / 20s / 30s / 1m (minute) / 2m / 5m / 10m / 20m / 30m / 1h (hour)
Initial value:
10s
(2) Processing mode (MEAS)
Specifies the calculation method of displayed and recorded measured values.
Setting range (selection type):
NORM / MAX / MIN / AVE
Initial value:
NORM
DPX21
Processing mode
NORM
(Instantaneous value)
MAX
(Maximum value)
MIN
(Minimum value)
AVE
(Average value)
When the measured value update cycle is set for 10 seconds, the measurement is performed
for 10 times every 1 second. When processing mode (MEAS) is set for AVE/MAX/MIN, the
maximum/minimum/average values of each 10 measured values are given as the measured
values.
THX21 THX11
Processing mode
NORM
(Instantaneous value)
MAX
(Maximum value)
MIN
(Minimum value)
AVE
(Average value)
Measured values at each measurement update cycle (CYCLE).
Maximum value of measured values at every 1 second during the
measured value update cycle (CYCLE).
Minimum value of measured values at every 1 second during the
measured value update cycle (CYCLE).
Average value of measured values at every 1 second during the
measured value update cycle (CYCLE).
Measured values at each measurement update cycle (CYCLE).
Maximum value of measured values at every 10 seconds during
the measured value update cycle (CYCLE).
Minimum value of measured values at every 10 seconds during
the measured value update cycle (CYCLE).
Average value of measured values at every 10 seconds during
the measured value update cycle (CYCLE).
4-5
4. Setting the Unit (Unit Operation)
Measured value
Measured value