Connecting To Network; Preparation - Omron ZN-DPX21-S Series User Manual

3.5 Connecting to Network

When connecting the unit to a network, set up network connection to the main unit.
Connect the LAN cable after making the network settings of the main unit.
Important
 Before connecting the product to a network, a full understanding of LAN is necessary.
 When connecting the unit via network, establish a dedicated LAN.
 When the unit is connected to an in-house network or LAN that has been already operated,
the number of available IP addresses may be limited and there may be some rules to be
followed. Contact network administrator. In such a case, operation of the unit or PC
software is not guaranteed.
 Even when using the default IP address and subnet mask, set the measurement operation
mode (MODE) to "NET". It will be not connected to network in "SLEEP" or "PD-S" mode.

3.5.1 Preparation

Before establishing network connection, define IP address and subnet mask to be used.
Seeting example
IP address of Air Thermo Station
IP address of PC
Subnet mask
IP Address: 192.168.0.20
Subnet Mask: 255.255.255.0
Note
 The factory default IP address for the unit is 192.168.0.20 and subnet mask is
255.255.255.0.
 When connecting the unit and PC to a network, IP address should not be overlapped with
other networked devices. In the example above, the IP address of the second unit is set as
192.168.0.21, while the address of the PC is set as 192.168.0.100. The fourth segment
value has been changed to distinguish between the devices.
DPX21 THX21
(First unit) 192.168.0.20 (factory default)
(Second unit) 192.168.0.21
192.168.0.100
255.255.255.0 (factory default)
PC
IP Address: 192.168.0.100
Subnet Mask: 255.255.255.0
LAN cable
IP Address: 192.168.0.21
Subnet Mask: 255.255.255.0
3-7
3. Check and Preparation
HUB
After Operation Check:
W4S1-05C