Omron ZN-DPX21-S Series User Manual page 56

(12) IP address and subnet mask (IP 1 to IP 4, SUB 1 to SUB 4)
Sets 4 segments of the IP address (IP 1 to IP 4) and 4 segments of the subnet mask (SUB 1
to SUB 4).
Setting range (numeric value input type):
IP 1, IP 2, IP 3, IP 4: 0 to 255
SUB 1, SUB 2, SUB 3, SUB 4: 0 to 255
Initial value:
IP 1. IP 2. IP 3. IP 4 = 192.168.0.20
SUB 1. SUB 2. SUB 3. SUB 4 = 255.255.255.0
Note
 The unit will be reset and restarted after changing the IP address and subnet mask after
confirmation with the SET/REC/STOP key and change the operation mode with the MODE key.
 When ETC is OFF and IP is OFF, the IP address and Subnet mask cannot be set.
(13) Display mode at sleep (SDISP)
Specifies whether or not performing display during operation in sleep mode.
Setting range (selection type):
OFF / ON
Setting value
OFF
ON
Initial value:
OFF
Refer to: 4.2.4(3) Measurement operation mode (MODE)
Note
 Pressing the key when the display is not shown in SLEEP mode only specifies to restart the
display. To execute functions allocated to the key, press the key again after the display is
shown again.
 When ETC is OFF, SDISP cannot be specified.
If there is no operation for 5 seconds during operation in sleep
mode, the display disappears.
When any key is pressed, the display will be restarted.
Continues the display even during operation in sleep mode.
4-10
4. Setting the Unit (Unit Operation)
DPX21
Operation
THX21