Preparing The Required Items - Omron EQUO Series User Manual

3.2

Preparing the Required Items

The following items are required to use this product.
CTX21
Dedicated CT: ZN-CT1-A
Up to three units can be connected when using a branch cable (ZN-CTM11-C)
AAA batteries (when using battery power supply)
Alkaline dry cells or nickel-metal hydride cells (Ni-MH)
Important
Manganese battery cells cannot be used.
Use two batteries of the same type. Do not mix new and used batteries.
KMX21
KM Series Power Sensors/Monitors
KM100 Power Monitor
KM20-B40-FLK Power Monitor
KM50- Power Monitor
KM-N1-FLK Power Monitor
KM-N2-FLK Power Monitor
KM-N3-FLK Power Monitor
Common
SD Memory Card (SDHC compatible)
Used to save measured data or to relocate the data
(when recording in a Portable Power Monitor/Power Sensor Station unit)
Recommended: HMC-SD291 (2 GB), HMC-SD491 (4 GB)
PC (personal computer) for the PC software
To connect the product with the network and use it, the following is necessary.
LAN Cable (10BASE-T or 100BASE-TX; Safety Category 5e or higher; Straight Type)
LAN Connection HUB (for 10BASE-T or 100BASE-TX)
Note
 Generally, the unit should be connected to a PC via a HUB.
1 (Separately sold)
2
Any of them in 1 to 31 units
(Sold separately)
1
1
3-1
3. Check and Preparation