FireplaceXtrordinair ProBuilder 72 Linear Installation Manual page 52

52
3 Spread an even layer of crushed glass over the media tray and burner. The glass must be only 1 layer thick
on the burner but can be 2 layers thick on the media tray. Make sure no glass is in the pilot area indicated
in the picture below.
4 Make sure the rear and end air channels are free of crushed glass. Use a screwdriver to clear this area.
Make sure the glass is only 1 layer deep on the burner.
5 Remove the pilot shield to uncover the pilot once you are finished placing the glass.
© Travis Industries
Installation
(for qualified installers only)
No glass in
this area
One layer thick
4/21/20 - 1458
2 layers thick
PB 72 MV/GSB2/GSR2 Install