Table of Contents
Advertisement
Available languages
Available languages
Installation
Gas Connection
GAS HOSE RESTRAINT
If the oven is mounted on casters, a commercial
flexible connector with a minimum of 3/4" (1.9 cm)
inside diameter must be used along with a quick
connect device.
The gas hose restraint (heavy gauge cable),
supplied with the oven, must be used to limit the
movement of the unit so that no strain is placed
upon the flexible connector. Locate the restraint as
follows:
The restraint bracket should be fastened to the
D
left rear oven support. See page 8 for installa-
tion of the restraint bracket.
The restraint should be short enough to prevent
D
any strain on the connector. See Figure 17 View
A for length adjustment detail.
With the restraint fully stretched the connector
D
should be easy to install and quick connect.
The permanent end of the restraint should be at-
tached without damaging the building. DO NOT
attach the restraint to the gas piping or electrical
conduit! Use anchor bolts in concrete or cement
block. On wooden walls, drive hi test wood lag
screws into the studs of the wall.
WARNING!!
If the restraint is disconnected for any
reason it must be reconnected when the
oven is returned to its original position.
View A
Tighten after
adjusting length of
cable
U.S. and Canadian installations
The connector must comply with the Standard for
Connectors for Movable Gas Appliances, ANSI
Z21.69 or Connectors For Moveable Gas Ap-
pliances CAN/CGA-6.16 and a quick disconnect
device that complies with the Standard for Quick-
Disconnect Devices for Use With Gas Fuel, ANSI
Z21.41 or Quick Disconnect For Use With Gas Fuel
CAN 1-6.9. Adequate means must be provided to
limit the movement of the appliance without de-
pending on the connection and the quick discon-
nect device or its associated piping.
A drip leg must be used at each appliance. Refer
to NFPA54/ANSI Z223.1 - Latest Edition (National
Fuel Gas Code) for proper drip leg installation.
Australia and General Export installations
The restraint and quick connect must conform
with Local and National installation standards. Lo-
cal installation codes and/or requirements may
vary. If you have any questions regarding the prop-
er installation and/or operation of your Blodgett
oven, please contact your local distributor. If you
do not have a local distributor, please call the
Blodgett Oven Company at 0011-802-860-3700.
Gas Supply Line
Socket
Plug
Quick Connect
Figure 17
20
Socket
Gas
Hose
(See View A)
Advertisement
Table of Contents
