JETWAY J-Mark J-530CF Manual page 42

4E Manufacturing POST Loop
or Display Messages
4F Security Check
50 Write CMOS
51 Pre-boot Enable
52 Initialize Option ROMs
53 Initialize Time Value
60 Setup Virus Protect
61 Set Boot Speed
62 Setup Num Lock
63 Boot Attempt
B0 Spurious
B1 Unclaimed NMI
E1-EF Setup Pages
FF Boot
Software Installed
4-1 Sound Card Driver Quick Installation:
Reboot if Manufacturing POST Loop pin is set.
Otherwise display any messages (i.e., any non-fatal
errors that were detected during POST) and enter Setup.
Ask password security (optional).
Write all CMOS values back to RAM and clear screen.
Enable parity checker.
Enable NMI, Enable cache before boot.
Initialize any option ROMs present from
C8OOOh to EFFFFh.
NOTE: When FSCAN option is enabled, will initialize
from C8OOOh to F7FFFh.
Initialize time value in 40h:BIOS area.
Setup virus protect according to Setup.
Set system speed for boot.
Setup Num Lock status according to Setup.
Set low stack.
Boot via INT 19h.
If interrupt occurs in protected mode.
If unmasked NMI occurs, display.
Press F1 to disable NMI, F2 reboot.
E1-Page 1, E2-Page 2, etc.
Chapter 4
41