JETWAY J-Mark J-530CF Manual page 41

18 Test 8259 Interrupt
Functionality
19 Test Stuck NMI Bits
(Parity I/O Check)
1A
1B-1E Reserved
1F Set EISA Mode
20 Enable Slot 0
21-2F Enable Slot 1-15
30 Size Base and Extended
Memory
31 Test Base and Extended
Memory
32 Test EISA Extended
Memory
33-3B Reserved
3C Setup Enabled
3D Initialize & install Mouse
3E Setup Cache Controller
3F Reserved
BF Chipset Initialization
40
41 Initialize Floppy
Drive & Controller
42 Initialize Hard Drive &
controller
43 Detect & Initialize
Serial/Parallel Ports
44 Reserved
45 Detect & Initialize
Math Coprocessor
46 Reserved
47 Reserved
48-4D Reserved
Force an interrupt and verify the interrupt occurred.
Verity NMI can be cleared.
Display CPU clock.
If EISA non-volatile memory checksum is good, execute
EISA initialization. If not, execute ISA tests an clear
EISA mode flag.
Test EISA Configuration Memory Integrity (checksum &
communication interface).
Initialization slot 0 (System Board).
Initialize slot 1 through 15.
Size base memory from 256K to 640K and extended
memory above 1MB.
Test base memory from 256K to 640K and extended
memory above 1MB using various patterns.
NOTE: This will be skipped in EISA mode and can be
"skipped" with ESC key in ISA mode.
If EISA Mode flag is set then test EISA memory found in
slots initialization.
NOTE: This will be skipped in ISA mode and can be
"skipped" with ESC key in EISA mode.
Detect if mouse is present, initialize
interrupt vectors.
Initialize cache controller.
Program chipset registers with Setup values
Display virus protest disable or enable.
Initialize floppy disk drive controller and drives.
Initialize hard drive controller and any drives.
Initialize any serial and parallel ports (also game port).
Initialize math coprocessor.
40
mouse, install