JETWAY J-Mark J-530CF Manual page 3

• DRAM Memory Support: support 3 168-pin DIMMS(3.3V)from a memory
size befween 8MB to 768MB.
• ISA and PCI ecpansion Slots: Privodes two 16-bit ISA slots, three PCI slots.
• Super Multi-I/O: Provides two high-Speed UART compatible serial ports and
one parallel port with EPP and ECP capabilities. UART2 can also be directed to the
Infrared Module for wireless connections. Two floppy drives of either 5.25" or 3.5"
(1.44MB or 2.88MB) are also supported without an external card.
• PCI Bus Master IDE Controller and ULTRA DMA 33: On-board PCI Bus Master
IDE controller with two connectors that supports four IDE devices in two channels,
provides faster data transfer rates, and supports Enhanced IDE devices such as Tape
Backup, CD-ROM drives and LS-120. This controller also supports PIO Modes 3 and
4 and Bus Master IDE DMA 33Mbyte/Sec.
• ACPI supporting for OS Directed Power Management
Ring-in Wake up: When Ring-In the system can wake up from SMI Mode.
Ring-in Power On: When Ring-In the system can power on automatic by
this function.
RTC Power On: Power On function, you can setting RTC alarm to power
on the system at the time length you setting .
Power Button: Press the button will place the system power on/off .
Software off when use ATX power supply.
• Power Support: Efficient PWM switching power instead of traditional Linear
Voltage Regulator to prevent power component from being burned-out.
• Meets PC99 Requirements.
• Optional IRDA and PS/2: This motherboard supports an optional infrared
port module for wireless interface and PS/2 mouse cable set.
• USB Port Connector: This motherboard supports two USB port
connectors for USB devices.
• Bundle with "Xstore Pro" High Performance ULTRA DMA 33 Driver to improve
IDE transfer rate up to 33Mbyte/sec. Increase System Performance 10% more,
Hard Drive performance 60% more.
• Micro ATX Form Factor: Dimensions 22cm x 24.5cm.
2