Table of Contents
Advertisement
Disabled:
No warning message to appear when anything attempts to access the
boot sector or hard disk partition table.
•
CPU Internal Cache / External Cache: These two categories speed up memory
access. However, it depends on CPU/chipset design. The default value is Enable. If
your CPU without Internal Cache then this item "CPU Internal Cache" will not be
show.
Enabled:
Enable cachehis category speeds up Power On Self Test.
(POST) after you power on the computer.
Disabled:
Disable cache
•
Quick Power On Self Test: If it is set to Enable, BIOS will shorten or skip some
check items during POST.
Enabled:
Enable quick POST
Disabled: Normal POST
•
Boot Sequence: This category determines which drive computer searches first for
the DOS (Disk Operating System). Default value is A,C,SCSI.
System will first search for floppy disk drive, then hard disk drive and then SCSI
device. The options are: C, A, SCSI; C, CDROM, A; CDROM, C, A; D, A, SCSI; E, A,
SCSI; F, A, SCSI; SCSI, A, C; SCSI, C, A; C only; LS/ZIP, C.
•
Swap Floppy Drive: The swap floppy drive. Default value is Disabled.
Enabled:
Floppy A & B will be swapped under the DOS
Disabled:
Floppy A & B will be not swap
•
Boot Up Floppy Seek: During POST, BIOS will determine if the floppy disk drive
installed is 40 or 80 tracks. 360K type is 40 tracks while 760K, 1.2M and 1.44M are
all 80 tracks. The default value is Enabled.
Enabled:
BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks.
Note that BIOS can not tell from 720K, 1.2M or 1.44M drive type as
they are all 80 tracks.
BIOS will not search for the type of floppy disk drive by track number.
Disabled:
Note that there will not be any warning message if the drive installed is
360K.
•
Boot Up NumLock Status: The default value is On.
On:
Keypad is number keys.
Off:
Keypad is arrow keys.
•
Boot UP System Speed: It selects the default system speed-the speed that the
system will run at immediately after power up.
High:
Set the speed to high.
Low:
Set the speed to low.
NOTE: The board default value is LOW in the field. Boot the system to controller turbo or De-
turbo by Onboard (Turbo Switch).
•
Typematic Rate Setting: This determines the typematic rate.
Enabled:
Enable typematic rate and typematic delay programming.
19
Advertisement
Table of Contents
