List Of Errors - JUKI PLC-2710V Instruction Manual

6-6. List of errors

Error
Description of error
code
E000 Execution of data initial-
ization (This is not an
error.)
E007 Motor overload
E009 Overtime of solenoid
energization
E011 Media is not inserted
E012 Read error
E013 Write error
E014 Write protect
E015 Format error
E016 External media over-ca-
pacity
E019 File size over
E022 File undetected
E032 File compatibility error
E071 Slip-off of the motor
connector
E072 Motor overload when the
thread trimmer operates
E079 Overload operation error • Load applied to the main shaft motor is
E081 Feed driving motor lock
E204 USB insertion
Cause
• The existing control box has been re-
moved and a new one is mounted.
• In the case the initialization operation is
executed.
• In the case the machine head is locked.
• In the case of sewing extra-heavy
weight material that exceeds the guar-
anteed material thickness.
• In the case the motor fails to rotate.
• In the case of the motor or driver failure.
• In the case the length of solenoid ener-
gizing time has exceeded the assumed
one.
• In the case no media is inserted.
• In the case data stored on the media
cannot be read.
• In the case data cannot be written on
the media.
• In the case the media is placed in the
write-prohibition state.
• In the case formatting of the media can-
not be carried out.
• In the case the capacity of media is not
enough.
• In the case of attempting to read the
custom pitch data or condensation cus-
tom data which exceeds the maximum
permissible data size into the memory
of sewing machine from the USB thumb
drive.
• In the case of attempting to read a file
which is not stored in the USB thumb
drive into the operation panel.
• In the case the file is not compatible.
• In the case the motor connector has
slipped off.
• Same as E007.
excessively large.
• In the case the feed driving motor is
locked.
• In the case the sewing machine is start-
ed up without removing the USB thumb
drive.
– 86 –
Item to be checked
This is not a failure.
• Check whether the pulley is entan-
gled with thread.
• Check whether the motor output
connector (4P) has loosened.
• Check whether the motor can be
turned smoothly by hand.
• Turn the power OFF and check for a
media.
• Turn the power OFF and check for a
media.
• Turn the power OFF and check for a
media.
• Turn the power OFF and check for a
media.
• Turn the power OFF and check for a
media.
• Turn the power OFF and check for a
media.
• Turn the power OFF and check the
USB thumb drive.
• Turn the power OFF and check for a
media.
• Check for looseness and slip-off of
the motor output connector.
• Same as E007.
• Check whether the feed driving motor
operates smoothly.
• Remove the USB thumb drive.