Table of Contents
Advertisement
5-4. Knee switch
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
❶
White line
Cords of knee switch
❷
Black (No. 18) White (No. 9)
18
9
10
1
Black line
(1) Installation of the knee switch
1) Assemble the knee switch ❶ . Then, fix it on the
undersurface of the table with a wood screw ❷ .
2) Connect the knee switch ❶ to No. 9 and No. 18
pins of the machine connector 18P which is con-
nected to CN36 of the machine controller.
(2) Functions of the knee switch
When knee switch ❶ is pressed, the data is changed
over to the data on one-touch changeover 4.
(Refer to
"6-2-8. One-touch utility changeover
function"
p.69)
The knee lifter switch can also be used as the
presser bar lifting lever through the relevant function
setting. (When it is used as the presser lifter switch,
it loses its function as the one-touch changeover 4
switch.)
– 39 –
Advertisement
Table of Contents
