Adjusting The Stitch Length; Changing The Sewing Speed - JUKI PLC-2710V Instruction Manual

4-4. Adjusting the stitch length

1. There may be the cases where the feed amount of the operation panel and the actual sewing pitch
are different from each other in case of the use in the state other than the standard delivery or ma-
terial used. Compensate the pitch in accordance with the sewing product.
2. Be aware that interference between the throat plate and feed dog can occur depending on the
gauge used. Be sure to check the clearance in the gauge to be used. (The clearance must be 0.5
mm or more.)
3. When you have changed the stitch length, feed dog height or feed timing, run the sewing machine
at a low speed to make sure that the gauge does not interfere with the changed part.

4-5. Changing the sewing speed

❶ A
❷ ❸
❶ A
❷ ❸
Stitch length is displayed in section A on the
panel. (Example of display : 6.0 mm)
[How to adjust]
1) When
input screen is displayed.
2) Change the stitch length by pressing numeric
keypad ❷ .
(Input unit: 0.1 mm; Input range: -9.0 to 9.0)
3) Confirm your entry by pressing
Then, the sewing screen is displayed.
The sewing speed is displayed in section A on
the panel. (Example of display : 3,000 sti/min)
[How to change]
1) Display the sewing speed entry screen by
pressing
2) Change the sewing speed as desired by
pressing ten keys ❷ .
3) Confirm your entry by pressing
Then, the sewing screen is displayed.
* The sewing speed may be automatically re-
duced according to the amount of the alternat-
ing vertical movement of the walking foot and
presser foot and the stitch length.
(Refer to "10. SEWING SPEED TABLE"
p.152)
– 28 –
❶ is pressed, the stitch length
❶ .
❸ .
❸ .