Toshiba MMU-UP0051MH-E(TR) Service Manual page 41

No. Item
6 Fan speed 1) By the command from remote control, fan speed is
selection
2) When the fan speed mode [AUTO] is selected, the fan
<COOL>
• Fan speed mode [AUTO] in case when remote
• If the fan speed has been changed once, it is not
• When cooling operation h as started, select a down-
• If the temperature is just on the difference boundary,
<HEAT>
( ) : indicate the value when the remote controller
• If the fan speed has been changed once, it is not
• When heating operation has started, select an upward
• If the temperature is at the difference boundary, the
• If TC2 ≥ 60˚C, the fan speed increases by 1 step.
Outline of specifications
changed. ((HH), (H+), (H), (L+), (L) or [AUTO])
speed varies by the difference between TA and Ts.
TA (˚C)
+3.0
HH
+2.5
<HH>
+2.0
H+ <HH>
+1.5
H <HH>
+1.0
L+ <H+>
+0.5
L <H>
Tsc
L <H>
–0.5
L <L+>
< > : Indicate automatic cooling.
controller sensor works is equal to that in case when
indoor unit sensor works.
changed for 3 minutes. However when the air volume
is changed, the fan speed changes.
ward slope for the fan speed, that is, the high position.
the fan speed is not changed.
TA (˚C)
L <L+>
(+0.5) +1.0
L+ <H>
(0) Tsh
H <H+>
(-0.5) -1.0
H+
<HH>
(-1.0) -2.0
HH
(-1.5) -3.0
<HH>
(-2.0) -4.0
< > : Indicate automatic heating.
Indoor unit sensor works.
Remote controller sensor works.
sensor is worked.
changed for 1 minute. However when the fan speed
changed, the fan speed changes.
slope for the fan speed, that is, the high position.
fan speed is not changed.
A
B
C
D
E
F
G
E
D
C
B
A
– 41 –
Remarks
HH > H+ > H > L+ > L > UL
Depends on fan speed mode
selection at the remote controller.
(H+) and (L+) cannot be selected.
For Floor Standing Concealed
Type,or Floor Standing Cabinet
Type, (HH), (H), (L) or [AUTO]
can be selected regardless of
remote controller models.
Code No. [32]
0000: Indoor unit sensor
(Main unit)
0001: Remote controller
sensor
TC2: Temperature of indoor
heat exchanger sensor