Toshiba MMU-UP0051MH-E(TR) Service Manual page 153

No. Part name
1. Detachment (In cases of UP027/UP048)
Drain pan
(Continued)
1) Perform work Detachment 1 of
Perform work Detachment 1 of
2) Take off the drain cap and then extract accumulated
drain water in the drain pan.
Note
When taking off the drain cap, be sure to receive drain
water in a bucket, etc.
3) Take off screw (M 4 × 8, 1 pc.) which fixes the partition
board and then remove it as if lifting up it.
• As shown in the right Photo, the drain pan is fixed by
4) Take off screws at 4 corners (M 4 × 8, 4 pcs.) which fix
the drain pan and then pull out the drain pan quietly.
2. Attachment (In cases of UP027/UP048)
1) Attach the drain pan as original while passing the fan
motor wiring and the drain pump sensor wiring through
the specified hole.
Note
Be sure to pass the drain pump sensor wiring through the
specified fixing slit of the inner foaming.
2) Attach all the partition board, electric parts box, ceiling
panel, air filter and center panel as original.
For wiring in the electric parts box, be sure to wire it
as original.
• Be sure necessarily to attach the drain pan fixing
Procedure
the drain pan fixing sheet metal at the both sides of
the fan motor. Take off each screw and then remove
the drain pan fixing board. (M 4 × 8, 1 pc. each)
sheet metal for UP048 type.
.
.
Screw Screw Screw
– 153 –
Remarks
In cases of UP027/UP048
Partition board Partition board Partition board
Screw Screw Screw
Drain cap
In case of UP048
Drain pan fixing board
Screw
Drain pump/
sensor wiring
Fixing slit Fixing slit Fixing slit
Screw Screw Screw