Entering Or Editing Programs - Omron SYSMAC CPM1 Operation Manual

Programming Console Operations
Corrected Program
00100 00101
00201 00102

4-3-9 Entering or Editing Programs

00002
1, 2, 3...
After completing the insertion and deletion procedures, use the Up and Down
Arrow Keys to scroll through the program and verify that it has been changed
correctly, as shown in the following diagram.
00104
00105
01000
END(001)
This operation is used enter or edit programs. It is possible in PROGRAM mode
only.
RUN
No No
The same procedure is used to either input a program for the first time or to
change a program that already exists. In either case, the current contents of
Program Memory is overwritten.
The program shown in the following diagram will be entered to demonstrate
this operation.
TIM 000
#0123
MOV(021)
#0100
LR 10
ADB(050)
#0100
#FFF6
DM 0000
1. Press the CLR Key to bring up the initial display.
2. Specify the address where the program will begin.
3. Input the address where the program will begin and press the Down Arrow
Key. It is not necessary to input leading zeroes.
C A A
2 0 0
4. Input the first instruction and operand.
LD
5. Press the WRITE Key to write the instruction to Program Memory. The next
program address will be displayed.
Address Instruction
00205 AND
00206 AND NOT
00207 OUT
00208 END(001)
MONITOR PROGRAM
OK
Address Instruction
00200 LD
12.3 s
00201 TIM
00202 MOV(021)
00203 ADB(050)
00200
↓
00200
C
2
LD
00201READ
WRITE
NOP(000)
Section 4-3
Operands
00105
00104
01000
-
Operands
IR 00002
000
#0123
#0100
LR 10
#0100
#FFF6
DM 0000
00002
65