Recovery Function; End Of Training And Standby - Kettler UM 678 Series Manual

200325 Comp-UM6786_7_03_20.de,en,fr_final_Layout 1 25.03.2020 10:40 Seite 23
UM6786/UM6787
RECOVERY Recovery pulse stage
The RECOVERY function can be used after each exercise program.
The RECOVERY button is used to initiate recovery pulse measurement
at the end of exercising. Initial and final pulse during one minute are
used to calculate deviation and a fitness score. In case of equal exercis-
ing, improvement of such score is a measurement for increase of fit-
ness.
When reaching the target values, end exercising and press the RECOV-
ERY button; then, leave your hands at the hand pulse sensors. In case
of previous pulse measurement, the display shows 00:60 for time, and
the PULSE display shows the current pulse value (flashing). The count-
down starts at 00:60. Leave your hands at the hand pulse sensors until
the countdown reaches >0<. The display will show on its right a value
between F1 and F6. F1 is the best status; F6 is the worst status. The
function can be ended by pressing again RECOVERY.
If no pulse is recorded during the time delay, the error message "Err" appe-
ars.
End of Training and Standby Mode
The display switches to standby mode with temperature display 4 minutes
after training if there are no longer any buttons being pressed, no pulses
arise owing to pedalling and no pulse is active.
It is possible to continue the last training session if the display is reactivated
by pressing a button or pedalling.
23
EN