Suzuki DR-Z400S 2001 Service Manual page 62

Hold the generator rotor using a 26 mm offset wrench, and
then remove the balancer driven gear nut.
Remove the plate, balancer driven gear, and key.
Hold the generator rotor using a 26 mm offset wrench, and
then remove the primary drive gear nut.
Remove the washer, primary drive gear, pin, key, and bal-
ancer drive gear.
The primary drive gear nut has left-hand threads.
Hold the generator rotor using a 26 mm offset wrench, and
then remove the generator rotor nut.
Remove the generator rotor using the special tool.
09930-31921: Rotor remover
NOTE:
Do not use the rotor remover attachment to remove the genera-
tor rotor, since it will not fit on the end of the crankshaft. As an
alternative, temporarily install the generator rotor nut to the crank-
shaft, and then remove the generator rotor using the special tool.
Do not hit the generator rotor with a hammer, other-
wise the rotor may be damaged.
Remove the key 1 and starter clutch gear 2.
ENGINE 3-19
2
1