Before Washing For The First Time; Transportation - Siemens WD14U560TR Instruction Manual And Installation Instructions

Positioning and connecting
en
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Tambur bakım (Drum Clean)
programme the first time without
laundry.
Note:
The appliance must have been
■
installed and connected properly.
~ "Positioning and connecting"
on page 13
Never switch on a damaged
■
appliance.
Insert mains plug.
1.
Turn the water tap on.
2.
Press the # button till the indicator
3.
lamp lights up, release the button.
The appliance is switched on.
Close the door. Do not load any
4.
laundry.
Select the Tambur bakım (Drum
5.
Clean) 90°C programme.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into the
7.
dispenser II.
Add standard detergent into the
8.
dispenser II according
to manufacturer's instructions for
light soiling.
To prevent over sudsing, use
Note:
only half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
9.
Select I .
10.
When the programme ends, press
11.
the # button till the indicator lamp
turns off, release the button.
Your appliance is now ready for use.
20

Transportation

e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose. ~ Page 45
Drain any residual water.
3.
~ Page 43
Disconnect the appliance from the
4.
mains.
Remove the hoses.
5.
Empty the dispensers.
6.
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers
Leaking detergent/fabric softener
can prevent the appliance from
working correctly, e.g. due to
damage to the electronics.
Empty the dispensers before
transporting the appliance.
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if
Note:
necessary.