Kenwood DeLonghi Cooking Chef KM070 Technical & Service Manual page 23

Disassembly Instructions
32. Inside the pedestal after all wiring removed,
except the two cables coming from the body
section. The power PCB (with the yellow
capacitors), and the control PCB (attached to
the side of the pedestal casing).
33. To remove the power PCB, undo the four
indicated screws. The PCB, and the carrier,
should then just lift off. Please note the correct
routings of the cables.
34. Undo the two indicated screws on the
pedestal to release the control PCB from the
casing.
35. The back of control PCB housing, showing
the cam where the speed control knob is
attached.
22