Base And Induction Assembly - Kenwood DeLonghi Cooking Chef KM070 Technical & Service Manual

Disassembly Instructions

Base and Induction Assembly

14. The correct alignment of the two NTCs
through the high temperature seat pad.
15. To remove the base moulding, first
remove the six feet, and then undo the T15
screw under each foot. When reinserting
the feet, ensure the correct alignment.
16. The base moulding and induction assembly
can be removed after disconnecting the three
power connections as shown.
17. Also disconnect the red and white wires
from the opposite site of the induction PCB,
and the two connectors from the rear of the
PCB. Please be aware that these are locking
connectors.
17