Kenwood DeLonghi Cooking Chef KM070 Technical & Service Manual page 21

Disassembly Instructions
26. To remove the induction coil from the
support casting, remove the three indicated
screws. The NTCs can be removed from the
induction coil by first releasing the two circled
screws. This releases the housing holding the
NTCs in place, and they can then be removed
by pushing through the top side of the
induction coil. Be careful not to lose the
springs from within the NTC housing.
27. The underside of the induction coil,
showing the induction coil NTC.
20