Kenwood DeLonghi Cooking Chef KM070 Technical & Service Manual page 19

Disassembly Instructions
18. Only remove the cable tie holding the two
cables to the induction PCB cover if necessary,
before lifting the whole base moulding /
induction assembly free. Please note that a
cable tie must be reapplied prior to
reassembly/re-fixing
assembly. This will require the removal of the
induction PCB cover to fit the new cable tie.
19. The base moulding and induction
assembly complete, after separation from the
body of the machine.
of the induction
20. To remove the induction PCB cover, undo
the six indicated T15 screws.
21. The PCB cover can be lifted off from the
PCB, but only a short way, due to the leads
connecting the fan held within the PCB cover
to the induction PCB assembly itself.
Disconnect this cable from the PCB to remove
the PCB cover and fan completely.
18