Kenwood DeLonghi Cooking Chef KM070 Technical & Service Manual page 20

Disassembly Instructions
22. The induction PCB assembly rests on four
pegs on the base moulding, and can be lifted
straight up and off the base moulding.
23. The reverse of the induction PCB assembly.
24. The underside of the machine, with base
moulding and induction assembly removed,
showing the induction coil and inside the
pedestal.
25. To remove the induction support casting
from the pedestal, remove the 6 screws (yellow
arrows) – these screws should be secured using
Threadlock 60026. Be aware of the (bowl
interlock) reed switch (circled) below the
support casting. It is not fixed but just slotted
into place. Once the support casting has been
lifted off, the spring holding the exhaust grille
can be unhooked (red arrows), if required.
19