Simplex Scanning
The setting orientation differs depending on whether the width of original is
within or larger than 297mm (11.7").
Original width
When placing an original
on the exposure glass
⇒ p.116 "Placing the
Original on the Exposure
Glass"
When placing originals
on the ADF
⇒ p.117 "Placing the
Originals in the ADF"
Setting when the net-
work TWAIN driver is
used
Settings for Send Scan
(Use [Original Settings] in
[Scan Settings] )
*1
Contact glass: Select when scanning from the exposure glass.
297mm (11.7") or less
Place the original so that the top
edge touches the top-left of the
exposure glass.
Place the top edge of the original
first.
Set [Orientation:] to
When the ADF is used, set [Side:]
to " Simplex ".
Note
❒ Set " ADF " or " Platen glass
*1
"
in [ Document: ].
Select [ : 1 Sided].
Note
❒ Because this is the initial val-
ue of this setting, you do not
need to change it.
wider than 297mm (11.7")
Place the original so that the top
edge touches the top-left of the
exposure glass.
Place the original so that the top
edge is set on the far side of the
original table.
.
Set [Orientation:] to
When the ADF is used, set [Side:]
to " Simplex ".
Note
❒ Set " ADF " or " Platen glass
*1
"
in [ Document: ].
Select [ : 1 Sided].
Original Orientation
.
113
4